Turning on the fadeout in the tileset

Moderators: Nighthawk4, Dungeon Masters

Post Reply
User avatar
GunnJ
CCC
CCC
Posts: 2492
Joined: Tue Jun 05, 2007 6:05 am

Turning on the fadeout in the tileset

Post by GunnJ » Tue Jan 04, 2011 11:52 pm

The tileset I am trying to use has an overabundance of bushes and branches and leaves right where I am trying to work on something. When I check my work in the mod, all the branchy leaves fade out so I can finally see what it is I am trying to work on, but bouncing back and forth between the two would be a massive time drain.

So is there a button or checkmark or anything that I can do in the toolset to turn on the fadeout? Please say yes?

Thanks
“If you can’t take the heat, don’t tickle the dragon.”

User avatar
Grunt
Team Member; Retired with Honors
Posts: 9422
Joined: Sat Jun 05, 2004 12:37 am
Timezone: I AM A TIME LORD
Location: Boston, MA

Re: Turning on the fadeout in the tileset

Post by Grunt » Wed Jan 05, 2011 12:06 am

Environment > Fade Geometry > Always :)
FletcherWiki

*Stepping out of a portal*
Nawen Amakiir: there he is.. *smirks* someone had to make an entrance
Fletcher Millstone: MILLSTONE! *arms held high*
Lilliana Be'letane: You're the worst, Fletcher.

User avatar
GunnJ
CCC
CCC
Posts: 2492
Joined: Tue Jun 05, 2007 6:05 am

Re: Turning on the fadeout in the tileset

Post by GunnJ » Wed Jan 05, 2011 12:38 am

:jump:
“If you can’t take the heat, don’t tickle the dragon.”

Post Reply